Add on to old reception desk

[Bojangles]

I think I would have had a few sleepless nights with that one, quite a lot could have went pear shaped. Did you have templates for all the glass pieces?

I templated the curved top, then cut 8mm curved mdf pieces on the cnc for the curved glass and made sure they were spot on with the curved templates.
3 site visits to make sure it was going to work. Worked out the straight glass on cad. Only part i was worried about was the glass that dropped down onto the disabled counter. Thankfully our workshop floor and the courts floor were level!

Nice one, I think they were lucky to get you..

Can I ask who fabricated the curved glass sections?