A recent one of ours

[Stretch]

Any tips on Nexuscad stretch? I really like the program to use, then you look at some of the CAD renders on here and it makes mine done on Nexus look very basic.

What I've done is to go on the Crown Website where they show the door colours and copied and pasted the jpeg/png images into the textures folder in Nexus. You do need to crop the images first to get any white lines or borders out but these colours then appear in the drop down menu when you are changing the image texture.

I've also done the same on the website of our granite company so that I can replicate the worktop finish.

I might, If I get the time, do a little tutorial page on here. I've found the software very easy to use and very customisable.

For example, 3 x 600mm tall units would normally be 1800mm wide, but when you add in the width of your handles, ....what is the overall width then???? And do Crown offer 2 types of this handle ie, 1 for single sided access and another for double sided access???

You need to allow an additional 30mm per profile rail. They do a single and double vertical profile rail but it's the same measurement.

For instance, 2 x 600 larder towers with LH tower handed left and the RH tower handed right would require 1230mm.

But if you were to have (from left to right):

1 x 20mm end panel
1 x 600 Larder handed left
1 x 600 Larder handed left
1 x 20mm end panel

You would need to allow 20 + 600 + 30 + 600 + 30 +20 = 1300