Just finished yesterday

[Stretch]

Well, technically that’s more than “a couple” of questions but I’ll do my best to answer them!

The handleless extrusion is brushed aluminium and not foil wrapped.

The plinths are acrylic with a mirror finish...so..a false mirror finish if you like. The corners on the island are mitred with a chop saw and glued with Mitre Mate to stop them being kicked apart.....or bashed by hoovers, mops etc.

I did question the under oven drawers at the design stage as they pull out from the side wherever the handleless extrusion is. I don’t think it’s ideal to pull out a drawer from one side or t’other.....but....we’ve done this in the past occasionally and it hasn’t caused problems. Space was an issue in this instance and adding a vertical rail either side wasn’t possible.

Just noticed the bottom drawer in the last pic...sorry Snezz....it seems to be a tad out of level! Easily adjustable of course. I’ll make sure I get back and do it and send an updated pic before we get to the social. 

All the fascias have 2mm ABS colour matched edging as per the fascias.