New member in need of help

Hello There, Guest! Register

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Thread Modes

New member in need of help

snezza Offline

Offline

KFF's Posting Legend

Posts: 4,545
Threads: 240
Likes Received: 401 in 307 posts
Likes Given: 154
Joined: Jan 2011
Reputation: 9
Tokens: 39,957

#7

11-12-2015, 09:11 PM

I would put the 10mm filler at the top, above the Tambour unit. If there is a Cornice/moulding at the top, the 10mm filler would be "lost" between the top of the cabinet and the underside of the Cornice.

Even if there is no moulding along the top, it will still look far better than anything you could do between the bottom of the Tambour unit and the 30mm worktop........Silicone..!....sorry Steve..but YUK..!!!!!!!

www.distinterior.com

Reply

« Next Oldest | Next Newest »

Messages In This Thread

New member in need of help - by Keislp - 10-12-2015, 11:37 PM

RE: New member in need of help - by steve the fitter - 10-12-2015, 11:54 PM

RE: New member in need of help - by jonny round boy - 11-12-2015, 10:59 AM

RE: New member in need of help - by steve the fitter - 11-12-2015, 07:14 PM

RE: New member in need of help - by jonny round boy - 11-12-2015, 07:30 PM

RE: New member in need of help - by steve the fitter - 11-12-2015, 07:53 PM

RE: New member in need of help - by snezza - 11-12-2015, 09:11 PM

RE: New member in need of help - by steve the fitter - 11-12-2015, 09:33 PM

RE: New member in need of help - by chip off the block - 11-12-2015, 10:56 PM

RE: New member in need of help - by snezza - 11-12-2015, 11:06 PM

RE: New member in need of help - by RyanRoberts22 - 12-12-2015, 01:18 AM

RE: New member in need of help - by kingfisher - 12-12-2015, 07:37 PM

RE: New member in need of help - by Caly - 13-12-2015, 10:33 AM

Users browsing this thread: 3 Guest(s)