12-09-2015, 05:27 PM
AHA!
Thanks Stretch!
Now I see how the Crown system works.
It is different to the system that my supplier uses. The shape of the Crown handles on the tall units are double skinned by the looks of those pictures, which would enable you to fix into them with the oven screws.
I can only assume that Daniel uses the same system as me, coz the shape of my profiles are a single extrusion (not hollow) and there is a deeper finger rebate than the Crown system. The downside to this is the fact that there is a larger void behind the oven fascia and nowhere to fix the oven into. If I try to fix the oven normally (at a very slight angle)with the black screws, then the screws would be visible when viewed from the outside.
That's the reason I phoned you a few weeks ago when I was doing that Fit. I couldn't work it out, and then I found the solid bars that act as the infill to fill the void.
PS. Sorry to hi-jack your thread Evostance, the job looks good!
Just one minor thing, could you not have found a more subtle ventilation grill for the Fri/Freezer? Perhaps a wider one but not as tall. Your eye does get drawn to it. Maybe a White one?
Just to clarify, this is the profile that my supplier uses.
https://www.ostermann.eu/webcontent/cms/...e_2014.pdf
Its on page 9, 10, and 11.
Thanks Stretch!
Now I see how the Crown system works.
It is different to the system that my supplier uses. The shape of the Crown handles on the tall units are double skinned by the looks of those pictures, which would enable you to fix into them with the oven screws.
I can only assume that Daniel uses the same system as me, coz the shape of my profiles are a single extrusion (not hollow) and there is a deeper finger rebate than the Crown system. The downside to this is the fact that there is a larger void behind the oven fascia and nowhere to fix the oven into. If I try to fix the oven normally (at a very slight angle)with the black screws, then the screws would be visible when viewed from the outside.
That's the reason I phoned you a few weeks ago when I was doing that Fit. I couldn't work it out, and then I found the solid bars that act as the infill to fill the void.
PS. Sorry to hi-jack your thread Evostance, the job looks good!
Just one minor thing, could you not have found a more subtle ventilation grill for the Fri/Freezer? Perhaps a wider one but not as tall. Your eye does get drawn to it. Maybe a White one?
Just to clarify, this is the profile that my supplier uses.
https://www.ostermann.eu/webcontent/cms/...e_2014.pdf
Its on page 9, 10, and 11.
![[-]](https://www.kitchenfittersforum.com/images/collapse.png)