Custom Kitchen Build

[jonny round boy]

Finally went back to take some pictures of this kitchen today. This was the narrow kitchen that required shallow-depth units & shaped worktops.

Carcases are made from birch ply, edged with birch veneer; drawer boxes are 12mm birch ply on Blum Tandem runners; doors are Multiwood 'Meldon Cream'; appliances and tap are CDA; sinks are Astracast; Worktops are Duropal, shaped & edged in Germany and supplied via snezza 31 - thanks mate!

Going in the door:


Tall housing with fridge & oven:




Then an angled unit going from full to reduced depth:


With angled drawer:


1000 wide pan drawers:


With hob & glass splashback over:


Unit to the right of the drawerpack has a Smiths SS5 hydronic plinth heater underneath:


Wall units above, 720 high but raised to the ceiling:


On the other side, a very shallow wall unit on the end wall:


Reduced depth free-standing washer, then sink cupboard:


Due to the reduced depth, a standard sink wouldn't fit so I used Astracast 'Onyx' sink & drainer, but each turned through 90 degrees:


Behind the sink run is a glass upstand & cill:


On the end of the sink run is another angled unit:


Worktop:




U/C lights are warm white LED strip attached to the back of the pelmet:


A couple of other shots:






I'm not overly keen on the mint green wall colour, but they like it!


Jonathan

---

I forgot to mention - Thanks also to @[PJK] who helped on this job!