13-08-2014, 06:33 PM
Exactly what PJK said.......
We've done a few of the Crown handless kitchens with the aluminium finger profiles and they do take a bit of setting up and working out.
How did you cut the aluminium rail?
I like the fact that the worktop has been done flush with the fascias. The thing we've found is that you need bring the base units off the wall from 555mm to 580mm to compensate for this otherwise you end up with a worktop at 575mm deep which can cause problems with sink and hob cut outs.
The tap does look a little close to the up stands, as does the back of the hob.
Great job for a DIYer nonetheless. I've seen a lot worse installed by so called "professionals".
We've done a few of the Crown handless kitchens with the aluminium finger profiles and they do take a bit of setting up and working out.
How did you cut the aluminium rail?
I like the fact that the worktop has been done flush with the fascias. The thing we've found is that you need bring the base units off the wall from 555mm to 580mm to compensate for this otherwise you end up with a worktop at 575mm deep which can cause problems with sink and hob cut outs.
The tap does look a little close to the up stands, as does the back of the hob.
Great job for a DIYer nonetheless. I've seen a lot worse installed by so called "professionals".
![[-]](https://www.kitchenfittersforum.com/images/collapse.png)