01-03-2014, 10:39 AM
Thanks for your kind words 
It's a good camera with a big wide angle lens, I do however need a flash and to learn how to use it! Still haven't figured out how to get the date to move from out of the corner! I do agree through, if I could get some professional photos taken when everything is all finished it will look a lot better!
The clear water sink you can get from Sterling, although not sure where the customer got theirs from.
There is no lighting in the room whatsoever at this point. They are having spots installed, but they wanted to wait for the kitchen to be in before they positioned them.
The tower units are tall, 2303 from the floor plus 19mm cornice. I really like the look of them being close to the ceiling too, they were a nightmare to stand up though!
The extractor is Siemens. It's the first down draft extractor I've installed. Had to be quite careful, the installation instructions specified a 113mm wide slot, but the width of the flange is only 120mm, leaving 3.5mm of coverage. Also as the fan box breached the drawer pack below I had to cut the back of the lower drawer box around the fan box, and had to lift the upper drawer up 15mm. Very nice extractor though, it has really powerful suction!
It's a good camera with a big wide angle lens, I do however need a flash and to learn how to use it! Still haven't figured out how to get the date to move from out of the corner! I do agree through, if I could get some professional photos taken when everything is all finished it will look a lot better!
The clear water sink you can get from Sterling, although not sure where the customer got theirs from.
There is no lighting in the room whatsoever at this point. They are having spots installed, but they wanted to wait for the kitchen to be in before they positioned them.
The tower units are tall, 2303 from the floor plus 19mm cornice. I really like the look of them being close to the ceiling too, they were a nightmare to stand up though!
The extractor is Siemens. It's the first down draft extractor I've installed. Had to be quite careful, the installation instructions specified a 113mm wide slot, but the width of the flange is only 120mm, leaving 3.5mm of coverage. Also as the fan box breached the drawer pack below I had to cut the back of the lower drawer box around the fan box, and had to lift the upper drawer up 15mm. Very nice extractor though, it has really powerful suction!
![[-]](https://www.kitchenfittersforum.com/images/collapse.png)