Recent installation

[PJK]

Stunning looking work Joe. Love it.

Never heard of clearwater sinks! Must google them.

[PREM]

Excellent Joe here comes the but.

Nothing to do with the fit which is faultless

Lighting, where is it, are they or you drilling the ceiling for spots ?

Photo's If you are turning out quality work like this the pictures need to reflect it. Either get a better camera and learn a bit about light and composition, or get it done professionally. Work like that needs to be viewed in all its glory.
Sorry to go on but we all fail in the camera department, spending weeks on a job and taking 5 mins to clear the tops and take a few snaps.

[Daniel]

I like this Joe, nice design and looks like a nice fit.

We often configure column units with handles with the rest of the kitchen handleless - works well….. if you meant it the oven door handle match is a great touch !!

Colours work well but I agree with Prem - get some pro pictures done and it will look a million times better.

The only thing I don't like is the curved end unit, sort of comes out of nowhere and then ends nowhere behind ….. but thats just being stupidly picky.

Top work

[Graftershave]

Nice job mate, love the grey doors, looks an excellent fit.

Are the larders tall or ceiling low? I like how there close to the ceiling

[Allan R]

Like it Joe looks excellent mate, I also like the look of the tall units close to the ceiling

what make of extractor is it?

[Joe the chip]

Thanks for your kind words

It's a good camera with a big wide angle lens, I do however need a flash and to learn how to use it! Still haven't figured out how to get the date to move from out of the corner! I do agree through, if I could get some professional photos taken when everything is all finished it will look a lot better!

The clear water sink you can get from Sterling, although not sure where the customer got theirs from.

There is no lighting in the room whatsoever at this point. They are having spots installed, but they wanted to wait for the kitchen to be in before they positioned them.

The tower units are tall, 2303 from the floor plus 19mm cornice. I really like the look of them being close to the ceiling too, they were a nightmare to stand up though!

The extractor is Siemens. It's the first down draft extractor I've installed. Had to be quite careful, the installation instructions specified a 113mm wide slot, but the width of the flange is only 120mm, leaving 3.5mm of coverage. Also as the fan box breached the drawer pack below I had to cut the back of the lower drawer box around the fan box, and had to lift the upper drawer up 15mm. Very nice extractor though, it has really powerful suction!